Get your kiss from that special someone with your very own missile toad!
The little fella is 3D printed and has a hanging hole through the missile
It is approximately 3x3x3
You can purchase it unfinished in plain white or plain green. On the flip side you can also get it painted green and grey - I’m no artist! The paint job is good, not amazing, but good, transitions may not be great etc (see listing photos)
You can also purchase ones with small defects for super cheap! The "Imperfect Random" choice will get you a frog (either green or white/you can add a note to your order requesting one color or the other, I will try to honor it if I have a defect in that color, if not I will send what I have) which has only one defect which is the bottom side of the rocket. The defect is not extremely obvious, some people may notice the defect when looking at the frog from the side, it is very obvious if looking from the bottom at the butt. I started out giving the defective ones away, and most people said none of their friends noticed it unless they really studied the ornament or it was pointed out to them. See last photo in this listing for image of defects. This item may also require some trimming around the base of the frog to remove some of the stabilizing brim from 3D printing - a razor blade or sharp knife will handle this task easily in less than a minute.
These frogs are 3D printed, they are not resin printed or injection molded! There may be layer lines visible (you can see some layer lines in the close up photo of the painted frog on the tree). You may need to do some minor trimming of stabilizing material around the base of the frog - a sharp knife or razor blade will do the job in just a minute or two
This design was created by “Nerys” from Thingiverse who built upon the original frog scan by “WorksBySolo” who both have their designs covered under the Creative Commons attribution license
https://www.thingiverse.com/thing:35595
https://www.thingiverse.com/thing:5155135
